The CAL indicator will stop flashing and remains on the screen for 3 seconds.

Eutech Instruments cannot accept any responsibility for damage or malfunction to the meter caused by improper use of the instrument.

Remember to fill in the guarantee card and mail it back to your authorized distributor or Eutech Instruments Pte Ltd.

This meter is a microprocessor- based instrument that is designed to be handy, user-friendly and capable of allowing one-hand operation.

It also has user-friendly features, all of which are accessible through the membrane keypad.

The primary display shows the measured conductivity or TDS reading.

The display also shows error messages, keypad functions and program functions.

Each button, when pressed, has a corresponding graphic indicator on the LCD.

See Figure 2. Some buttons have several functions depending on its mode of operation.

When you switch on the meter, the meter starts up in the mode that you last switched off from.

Cyberscan Driver To Remove

Use a Philips screwdriver to remove the two screws holding the battery cover.

Lift meter stand to expose battery cover.

Insert batteries.

Follow the diagram inside the cover for correct polarity.

Replace the battery cover into its original position using the two screws removed earlier.

Slide the electrode connector of electrode over the socket of the meter (BNC connector).

Ensure that the slot of the connector is inline with the protrusions of the socket.

The meter provides a slot on the side of the instrument for the electrode holder.

Care must always be taken to avoid use of excessive force in the process of attaching these components.

Align the end of the electrode (sensor side) with the hole of the holder.

Cyberscan Software That Read

This format allows the data to be imported by a wide variety of software that read ASCII data (e.g.

LOTUS 123 C, Microsoft Excel, etc.).

Eutech Instruments also provides software that can capture the data transmitted into an ASCII file for later use.

Figure 11: Pin number position of the 9-pin RS 232 port The meter uses hardware handshake i.e.

Ensure that the calibration solution which you use comes with a Temperature vs Conductivity or a Temperature vs TDS.

The s indicator appears in the upper right hand corner of the display.

Method 1 relies on the availability of a table that shows the TDS values of the TDS calibration buffer solution at various temperatures.